Sunday, February 28, 2016

A Guide In Doing Reflow Soldering Oven

By Kenneth Williams


You can do this and it can be made possible. Especially if you want to experiment. Do not worry, this is used by many people around the world. And it became successful. Later, you will be given a guide so you know how to do it by yourself. It is fun and you will be amazed of the results after. And just prepare the necessary materials needed before you start.

Put them in one place together. And have a copy of the instructions so you it will not be very difficult. Get a piece of paper if you have not tried this before. And make sure that you follow everything and the way they instruct you to do it. It is necessary so you will be successful in doing the Reflow soldering oven. Do not invent something if you have no enough basis for it. To avoid accident.

Prepare the thermometer together with the timer. You will be using them once you plug them in to the switch. You can use the one that is found on the oven but best you will have something that you would use outside.To carry them around with you. And check the temperature.

Time to make the motherboard. It will not take time for you. Especially you have a draft of it already. And how do you want them to be. This will be your plan. Better check everything and see if there is lacking. So there is no regrets later. If there is something that you missed, you would have to start from scratch again.

Add flux. The purpose of putting one for easy modification. And can be used as marker too. Apply it to the balls. So they will be protected. And to avoid them from keep moving around the board. It is very important that they must stay in their specific location.

Align the components. You need to do this, so it will be easy for you to recognize them and identify all the parts. And put them inside the oven. Make sure that you can clearly see the activities inside so you can monitor them. If you have a silk screen, use it for the alignment. It is the advise of most experts.

Start them cooking. Ensure that they perfectly fit inside. And the surface must be elevated. You can now turn on them on to see the outcome of experiment. The maximum time you would cook them are 20 minutes. Do not go beyond the time limit so they will not damage. Make sure you close the door once the cooking is ongoing. You are not allowed to open them if the allocated time is not yet over.

Let them cool. If the time is over, then open the door. So they will cool faster. This is the only way for you to cool them down. Never touch anything on the surface especially the components. Since they are still in liquid state. If you notice the temperature that it is already 50 degree Celsius, then it is a sign to take them out.

Check them after. You have to check after. This is necessary that all components are still present. And you have achieved what you wanted. When all have been connected then, it is a sign that you are successful.




About the Author:



No comments:

Post a Comment